DO NOT attempt to repair gas valve.
DO NOT attempt to repair ignition module.
DO NOT attempt to repair venturi.
DO NOT attempt to repair thermostat board.
DO NOT attempt to repair transformer.
DO NOT attempt to repair pressure switch.
To avoid damage or injury, there must be no materials stored against the water heater or vent-air intake
system, and proper care must be taken to avoid unnecessary contact (especially by children) with the water
heater and vent-air intake system. UNDER NO CIRCUMSTANCES SHOULD FLAMMABLE MATERIALS,
SUCH AS GASOLINE OR PAINT THINNER BE USED OR STORED IN THE VICINITY OF THIS WATER
HEATER, VENT-AIR INTAKE SYSTEM OR IN ANY LOCATION FROM WHICH FUMES COULD REACH
THE WATER HEATER OR VENT-AIR INTAKE SYSTEM.
General
Water heater maintenance includes monthly tank flushing and cleaning and removal of lime scale. The unit
should be inspected and adjusted to maintain proper combustion. Refer to Table 7 – Suggested Maintenance
Schedule. An annual inspection of the venting system should be made.
Burner Flame Check
At the time of installation and at monthly intervals, a visual check of the burner flames should be made to
determine if they are burning properly. The main burner may be seen through the sight glass window on the
front of the combustion insert mounting bracket (see Figure 32). The burner flames should be a blue flame
near the burner surface in a uniform flame pattern. Occasional yellow or white streaks are normal.
SECTION X: MAINTENANCE
DANGER
WARNING
Figure 32 - Sight Glass Location
47