Table of Contents
Advertisement
The most common termination is alligator type clips. If this is your choice of leads, simply connect one clip
to one end of your load and the other clip to the opposite side of the load.
For flat surfaces, you can choose between two different spring-
loaded surface probes. If this is your choice of leads, simply press
one probe against one side of the surface of your load, making
sure that the surface of the probe is in full contact with the
surface of the load. Press the second probe against the surface
at the oppose side of your load making sure that the surface of
the probe is in full contact with the surface of the load.
For hard-to-reach surfaces, Valhalla Scientific offers two
different sets of spring-loaded dual needle probes that
differentiate in overall size and distance between the needles. If
this is your choice of leads, simply press both the needles of one
probe against one end of the surface of your load, press both
needles of the second probe against the surface at the oppose
end of your load.
See chapter 5 for a full list of lead sets and accessories for your
4314Ki.
17
Advertisement
Table of Contents
