Table of Contents
Advertisement
Connect the Wiring
The WTC ships with a 24 V power terminal strip with wire pigtail, spacers, and
all required screws and connectors for the installation.
24 V power pigtail
receptacle
RP-SMA connector
port for external
antenna
The antenna jumper is set to use the internal whip antenna by default, position
2 and 3. If your installation uses the external antenna option, adjust the
jumper position to 1 and 2 (move it left).
1. Pull the two 24 V power supply wires into the electrical box and strip
11 mm (7/16 in) of insulation.
2. Strip 11 mm (7/16 in) of insulation from both the red and black pigtail
wires.
3. Use the WAGO connectors provided to connect the power pigtail and the
power supply output wires. Use one WAGO for the red wire (positive +)
and one for the black wire (negative -). Open the terminal levers on the
WAGO connector and insert the power supply wire and the lead from the
pigtail into the terminals, then close the levers. Tug the wires to ensure
they are secure.
4. Connect the two-pin connector to the power pigtail receptacle on the
station.
5. If using the external antenna option, connect the patch cable to the
RP-SMA connector port. Ensure the jumper is set to position 1 and 2.
Note:
5
If using the External Antenna Extension kit, the
connection for the flexible coaxial patch cable (part
number N1124) may be outside the electrical box.
Jumper setting
for antenna
Internal whip
antenna
Wireless TimeClock Configuration Guide
Advertisement
Table of Contents
