Makita HR007G Instruction Manual page 10

Hammering only
For chipping, scaling or demolition operations, turn
the action mode changing knob to the
pressing the release button on the knob. Use a bull
point, cold chisel, scaling chisel, etc.
Fig.8
► 1. Hammering only
Hook
Optional accessory
CAUTION:
Always remove the battery when
hanging the tool with the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
The hook is convenient for temporarily hanging the tool.
Before installing the hook, remove the rubber cap from
the screw holes in the mounting bracket. Insert the plate
washers under the bracket, and then tighten the hook
with screws in place.
2
3
Fig.9
► 1. Rubber cap 2. Mounting bracket 3. Plate washers
4. Hook 5. Screws
symbol while
1
1
4
5
10 ENGLISH
For use, lift up the arm of the hook until it snaps into the
open position.
When not in use, be sure that the hook is folded back in
the closed position.
1
Fig.10
► 1. Hook 2. Open position 3. Closed position
Fig.11
Connecting lanyard (tether strap) to
the hook
CAUTION:
Do not use damaged hook and
screws. Before use, always check for damages,
cracks or deformations, and make sure that the
screws are tightened.
CAUTION:
Make sure that the hook is
securely installed with the screws.
CAUTION:
Do not install or remove any
accessory while hanging the tool. The tool may fall
if the screws are not tightened.
CAUTION:
Always use a locking carabiner
(multi-action and screw gate type) and be sure
to attach the lanyard (tether strap) to the double
looped portion of the hook. Improper attachment
may cause tool drop from the hook and result in
personal injury.
2
3