Makita UB401MP Original Instruction Manual page 7

4. To prevent dust irritation the wearing of a face
mask is recommended.
5. While operating the machine, always wear
non-slip and protective footwear. Non-skid,
closed-toed safety boots and shoes will reduce the
risk of injury.
6. Wear ear protection, such as ear muffs.
Exposure to noise can cause hearing loss.
7. Start and operate the engine only outdoors in
a well ventilated area. Operation in a confined or
poorly ventilated area can result in death due to
suffocation or carbon monoxide poisoning.
Operation
1. Clear the area of children, bystanders, and
pets. At a minimum, keep all children, bystand-
ers, and pets outside a 15 m radius; outside
the 15 m zone, there is still a risk of injury
from thrown objects. Bystanders should be
encouraged to wear eye protection. If you are
approached, stop the engine or machine.
► Fig.1
2. Switch off the blower and remove the battery
cartridge or the spark plug cap, and make sure
that all moving parts have come to a complete
stop
• whenever you leave the blower.
before clearing blockages.
•
• before checking, cleaning or working on
the blower.
• if the blower starts to vibrate abnormally.
Operate the blower only in daylight or in good
3.
artificial light.
Do not overreach and keep proper balance and
4.
footing at all times.
5. Always be sure of your footing on slopes.
6. Walk, never run.
Keep all cooling air inlets clear of debris.
7.
8. Never blow debris in the direction of
bystanders.
9. Operate the blower in a recommended position
and on a firm surface.
10. Do not operate the blower at high places.
11. Never point the nozzle at anyone in the vicinity
when using the blower.
12. Never block suction inlet and/or blower outlet.
• Be careful not to block suction inlet or
blower outlet with dust or dirt when oper-
ating in dusty area.
• Do not use nozzles other than the nozzles
provided by Makita.
Do not use the blower to inflate balls,
•
rubber boat or the similar.
13. Do not operate the blower near open window,
etc.
14. Operating the blower only at reasonable hours
is recommended - not early in the morning or
late at night when people might be disturbed.
15. Using rakes and brooms to loosen debris
before blowing is recommended.
16. Before blowing, slightly dampen surfaces in
dusty conditions or use water mist sprayer if
necessary.
17. Adjust the length of the blower nozzle so that
the air stream can work close to the ground.
18. If the blower strikes any foreign objects or
should start making any unusual noise or
vibration, immediately switch off the blower
to stop it. Remove the battery cartridge or the
spark plug cap, and inspect the blower for
damage before restarting and operating the
blower. If the blower is damaged, ask Makita
Authorized Service Centers for repair.
19. Do not insert fingers or other objects into
suction inlet or blower outlet.
20. Prevent unintentional starting. Ensure the
switch is in the off-position before inserting
battery cartridge, picking up or carrying the
blower. Carrying the blower with your finger
on the switch or energizing the blower that has
the switch on invites accidents.
21. Never blow dangerous materials, such as
nails, fragments of glass, or blades.
22. Do not operate the blower near flammable
materials.
23. Avoid operating the blower for a long time in
low temperature environment.
24. Before assembling or adjusting the machine,
switch off the motor and remove the spark
plug cap or the battery cartridge.
25. Wear the personal protective equipments
before starting the motor.
26. Before starting the motor, inspect the machine
for damages, loose screws/nuts or improper
assembly. Check all control levers and
switches for easy action. Clean and dry the
handles.
27. Never attempt to start the motor if the machine
is damaged or not fully assembled.
28. Adjust the shoulder harness and hand grip to
suit the operator's body size.
29. With the engine running only at idle, attach the
shoulder harness.
30. During operation, use the shoulder harness.
Keep the machine on your right side firmly.
► Fig.2
31. Hold the front handle with the left hand and the
rear grip with the right hand, no matter you are
right-hander or left-hander. Wrap your fingers
and thumbs around the handles.
32. Never attempt to operate the machine with one
hand. Loss of control may result in an injury.
33. If the machine gets heavy impact or fall, check
the condition before continuing work. Check
the fuel system for fuel leakage and the con-
trols and safety devices for malfunction. If
there is any damage or doubt, ask our autho-
rized service center for the inspection and
repair.
34. Follow the instruction manual of the power
unit for proper use of the control lever and
switch.
35. During or after operation, do not put the
hot machine onto dry grass or combustible
materials.
36. Refer to the instruction manual of the power
unit for how to start and control the machine.
7 ENGLISH