Sony STR-DA5200ES Operating Instructions Manual page 37

• All settings in the Auto Calibration
settings, Surround settings, Multi Zone
settings, Audio settings, Video settings,
System settings menus.
• The sound field memorized for each
input and preset station.
• All preset stations.
• All index names for inputs and preset.
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the RM-
AAL006 remote commander.
Insert two R6 (size-AA) batteries in the RM-
AAU009 remote control.
Observe the correct polarity when installing
batteries.
RM-AAL006
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 112).
Tip
When the remote no longer operates the receiver,
replace all the batteries with new ones.
The receiver and the remote use the same
command mode.
If the command modes of the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
If the command modes of both the receiver and
the remote are those of the initial setting (AV
SYSTEM 2), it is not necessary to reset them.
You can switch the command mode (AV
SYSTEM 1 or AV SYSTEM 2) of the receiver
and the remote. If both the receiver and the
other Sony component respond to the same
remote command, switch the command mode
of either the component or the receiver to
another command mode so that the component
does not respond to the same remote command
as the receiver.
To switch the command mode
of the receiver
RM-AAU009
Turn on the receiver while pressing
2CH.
When the command mode is set to "AV2,"
"COMMAND MODE [AV2]" appears on the
display.
When the command mode is set to "AV1,"
"COMMAND MODE [AV1]" appears on the
display.
About the command mode
2CH
continued
37 GB