Table of Contents
Advertisement
Blocking all
If you want to block
unknown calls.
all unknown calls with
numbers that are not in
your directory or allow
list, change the settings to
block calls without numbers
and uncategorized calls.
See Control calls without
numbers on page 38
and Control uncategorized
calls on page 39.
Forwarding
If you want to forward
all unknown
all unknown calls with
calls to the
numbers that are not in
answering
your directory or allow list
system.
to the answering system,
see Control calls without
numbers on page 38
and Control uncategorized
calls on page 39 to
change the settings.
The messages
If a caller leaves a very long
on the
message, part of it may be
answering
lost when the answering
system are
system disconnects the call
incomplete.
after the preset recording
time.
If the memory on the
answering system becomes
full during a message, the
answering system stops
recording and disconnects
the call.
If the caller's voice is very
soft, the answering system
may stop recording and
disconnect the call.
The answering
system does
not respond
to remote
commands.
I accidentally
set my LCD
language to
Spanish or
French, and
I don't know
how to change
it back to
English.
71
Make sure you enter the
correct remote access
code.
Make sure you are
calling from a touch-tone
telephone. When dialing
a number, there should be
tones. If there are clicks,
then it is not a touch-tone
telephone and cannot
activate the answering
system.
The answering system
may not detect the
remote access code when
your announcement is
playing. Wait until the
announcement is over
before entering the code.
While the handset is not in
use, press MENU and then
enter 364# to change
the handset LCD language
back to English.
Advertisement
Table of Contents
