Advertisement
1.8
Position the generator set onto the sound shield
base (GM86014 or GM86015) and secure the set
with 4 bolts (X-6238-3 or X-6238-11) and 4 washers
(X-25-37). See Figure 3.
For UMS Kit GM88267-KP1/-KP2/-KP3 only:
Install two base plates (GM88919 or GM88920)
onto sound shield base (GM86014 or GM86015).
Top View of Base
1. Engine end
2. Mounting hole locations
Figure 3 Sound Shield Base Mounting Position
1.9
Remove the end bracket cover. See Figure 4.
Save the mounting hardware and discard the
cover.
1
1. End bracket cover
Figure 4 End Bracket Cover
1.10 Remove the belt guard by removing the belt guard
brackets and hardware.
TT-1601
5/16
2
1
GM86014-B
GM79560-
2.
Construct the framework.
2
1
3
12
11
10
9
6
8
7
1. Rails (GM86079 qty. 4)
2. Internal rail (GM86084), bolts (X-6224-20 qty. 2), washers
(X-25-37 qty. 2), and nuts (X-6210-7 qty. 2)
3. Mounting bracket (GM86091), bolts (X-6224-20 qty. 4), and
nuts (X-6210-7 qty. 4) on each end of rail (GM86084)
4. Upper bulkhead (GM86074)
5. Internal rail (GM86085), mounting bracket (GM86091),
bolts (X-6224-20 qty. 3), and nuts (X-6210-7 qty. 3) on the
top of each rail. See Figure 15.
6. Extrusion mounting bracket (GM85876 qty. 3). See
Figure 7.
7. LH bulkhead (GM86076)
8. RH bulkhead (GM86075)
9. Internal rail (GM86085). See Figure 7.
10. Mounting bracket (GM86091), bolts (X-6224-20 qty. 4), and
nuts (X-6210-7 qty. 4). See Figure 15.
11. Corner extrusion mounting brackets (GM85875 qty. 4).
See Figure 6.
12. Internal rail (GM86082 or GM86083), mounting brackets
(GM86091 qty. 2), bolts (X-6224-20 qty. 8), and nuts
(X-6210-7 qty. 8)
Figure 5 Sound Shield Framework Installation
2.1
Cut foam (GM87549 or GM88912) to length and
insert into the four rails (GM86079). Save
remaining foam for later.
2.2
Secure the rails (GM86079 qty. 4) to each corner
using the mounting bracket and hardware
identified in Figure 6.
2.3
Position the internal rails (GM86085 qty. 2) at the
location shown in Figure 5 using the mounting
bracket and hardware identified in Figure 7.
Position a mounting bracket (GM86091) to the top
of each internal rail using three bolts (X-6224-20)
and three nuts (X-6210-7) per bracket. See
Figure 15 for more detail.
3
5
4
1
6
GM86016-
3
Advertisement
