3. Enter the Mac Address and Device ID of the GarageSmart
information can also found on the bottom of the GarageSmart
within your online control panel).
4. Click "Submit".
5. The GarageSmart
each garage door will OPEN and then CLOSE one at a time. During the test, the
status LED will blink a pattern as shown in the table below indicating the test
number being performed. The total test time is approximately 3 minutes long
Test
1
2
3
4
5
6
6. During the test if one or more garage doors do not open or close, then check the
garage door drive wires for any loose or broken wires. See "Connecting the
GarageSmart™ device to the Garage Door Motor" section in this manual.
7. Testing has ended and normal operation will resume when the status Led stops
blinking.
1.
For locations that have fewer than three (3) garage doors, the test will still run for approximately 3
minutes.
™
device will run a garage door test (starting with Test 1) in that
Led Color
Number of
Blinks
RED
1
GREEN
1
RED
2
GREEN
2
RED
3
GREEN
3
GarageSmart
TM
User's Manual
™
device (this
device or shown
™
Garage Door
Result
1
Opening
1
Closing
2
Opening
2
Closing
3
Opening
3
Closing
(1)
.
27