Garage Smart GS100 User Manual page 16

11. Login back into your routers Wi-Fi settings and change the Network Name
(SSID) and Password to match the Network Name (SSID) and Password that
was entered in Step 9 above.
12. Wait for the router to fully update to the new settings before proceeding with the
next steps.
13. Remove power from the GarageSmart
power to the GarageSmart
14. The Status LED on the left will start to blink a pattern of color(s) while it tries to
connect to your routers new Wi-Fi network settings.
15. If the LED eventually changes to only a blinking
then the GarageSmart
existing or new Wi-Fi settings.
At any time now or in the future, you may proceed to the section, "Verify the
GarageSmart™ Device is connected to your Wi-Fi network" of this manual to
visual test if the GarageSmart
the GarageSmart
16. If the LED does NOT eventually change to blinking
GarageSmart
new Wi-Fi settings
assistance on configuring the device properly.
A RULE OF THUMB – To skip steps 2 thru 7 above during future Wi-Fi configurations,
always update the Wi-Fi settings of the GarageSmart™ device first, before modifying the
Wi-Fi settings of the router since the two devices would already be on the same Wi-Fi
network.
Visit www.garagesmart.net/videos/to view a video on how to Configure the
GarageSmart™ Device to a secure Wi-Fi network.
1. If you do NOT have access to your routers Wi-Fi settings or if your router doesn't allow the changing
of the Network Name (SSID) or Password, then contact your Internet Service Provider (ISP) on how
to change these Wi-Fi settings or contact GarageSmart™ for assistance on configuring the device
properly.
2. Changing the Network Name (SSID) and Password of your router is only temporally, as your router
needs to initially establish communications with the GarageSmart™ device by being on the same
Wi-Fi network. Once, initial communication has been established, the GarageSmart™ device can
then be updated to your routers existing secured Network Name (SSID) and Password.
3. The last known Network Name (SSID) and Password of the GarageSmart™ device may either be its
factory default setting (for new factory devices that have never been configured yet) or the current
Wi-Fi Network (SSID) and Password that your router is set to (assuming that your routers Wi-Fi
settings haven't changed). However if the Wi-Fi Network Name (SSID) or Password of the
GarageSmart™ device is unknown, then contact GarageSmart™ for assistance on configuring the
device properly.
16
™ device.
™ device has been successfully updated with your routers
™ device is actually connected to your router and
™ network.
™ device Wi-Fi settings did NOT update correctly to your routers
(5) . Perform this section again or contact GarageSmart
GarageSmart TM User's Manual
™ device, wait 5 seconds, then reapply
GREEN (4) after a few seconds,
GREEN
(4)
, then the
™ for