GE JSP38 Use And Care Manual page 31

You may notice some white ash in
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-filled
a vinegar and water mixture.
usually a salt residue that cannot be removed by the
clean cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the AUTO SELF CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
. ~OTE: Before beginning, make sure the oven clock
shows the correct time of day.
Follow the directions in the Before a Clean
1.
Cycle section.
2. After closing the door, press the AUTO
AUTO SELF
CLEAN pad.
SELF
CLEAN
3. Press the INCREASE or DECREASE
pad to enter Clean Time.
4. Press the STOP TIME pad. "STOP
will appear in the display.
can set
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If the
Clean Time is three hours and the time of day is 6:00,
the Stop Time that appears in the display will be 9:00.
the oven. Just wipe
These deposits are
If the oven is not clean after one clean cycle,
repeat the cycle.
If the shelves become hard to slide, wipe the shelf
supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example: If
you set Stop Time at 11:00, oven will start clean
cycle at 8:00 and end at 11 :00. The door latches
automatically.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for clean cycle
is set. The words "ON" and "LOCK" will appear in
the display when the door automatically locks.
It will not be possible to open the oven door until
the temperature drops below the lock temperature
and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
During a delayed self-clean operation you
AUTO SELF
can find out when the oven is set to turn
CLEAN
on by pressing and holding the AU-TO
SELF CLEAN pad for 3 seconds.
A fan may automatically turn on and off to cool
internal parts. This is normal, and the fan may
continue to run after the oven is turned off.
31