Starting The Pt For The First Time - Omron NS7 Series Setup Manual

3-2-2

Starting the PT for the First Time

Always perform the following operations when turning ON the PT for the first time after pur-
chase.
1. Language selection.
2. Format the screen data area.
3. Set the date and time.
Operate according to the following conditions.
a) When the power is turned ON to the PT, the following error message will be displayed. Press the
OK Button.
b) The System Menu will be displayed. Press the Initialize Tab. The dialog boxes and System Menu
are set for English-language displays at the factory. The language can be changed to Japanese at
this point if desired. To change to Japanese, select it and then press the Write Button. The follow-
ing message will be displayed. Press the Yes Button. Do not turn OFF the power supply until the
language change process has been completed.
c) Press the Screen Data Area Button.
d) The following message will be displayed. Press the Yes Button to format the screen data. Do not
turn OFF the power while formatting is in progress. If an Expansion Memory Board is installed in
the PT, do not remove the Expansion Memory Board while formatting is in progress.
The time required for formatting depends on whether expansion memory is used and the size of
the expansion memory. The NS7 finishes formatting instantly.
e) When formatting has been completed, a message saying that formatting has been completed will
be displayed. Press the OK Button.
3-2 Starting the PT
3-9