Setting Ethernet - Omron NS7 Series Setup Manual

Reference
6-6-4

Setting Ethernet

To use Ethernet, select the Comm Tab from the System Menu and press the Enable Button.
The setting items for Ethernet will be displayed on the right side of the screen. Display and
set the network address, node address, IP address, subnet mask, and default gateway. Dis-
play the MAC address and IP address table display.
After setting, press the Write Button.
• Setting Ethernet Communications Conditions
Setting item
Network Add.
Node Add.
IP address
Sub-net
Default gateway
MAC address
IP address table display
Note: Do not set the following values for the IP address.
Host ID with all bits set to 0 or 1 (e.g., 192.168.21.0).
Net ID with all bits set to 0 or 1 (e.g., 255.255.21.16).
Subnet ID with all bits set to 1 (e.g., 192.168.255.16).
IP addresses that begin with 127 (e.g., 127.35.21.16).
The unit number is the number used by the host to identify each PT when more than
one PT is connected to a single host.
The unit numbers that can be set depend on the type of host used, as follows:
• C200HE(-Z):
Unit numbers 0 to 3 (up to four PTs for each port of the host)
• C200HG(-Z), C200HX(-Z), CS1G/H, CS1G/H-H, CQM1H, CJ1G, and CJ1G/H-H:
Unit numbers 0 to 7 (up to eight PTs for each port of the host)
Refer to 4-2 1:N Connection to the Host for the host settings.
Sets the network address used for
Ethernet communications.
Sets the local node address.
Sets the local IP address.
Sets the subnet mask of the local node.
Sets the IP router.
Displays the MAC address (device-
specific information to identify each de-
vice connected to the network.)
Displays the node number and IP ad-
dress of other nodes connected to
Ethernet.
Function
1 to 127
0 to 126
0.0.0.0 to 255.255.255.255
(See note.)
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
Read-only.
Read-only.
6-6 Communications Settings
Settings
6-27