Audio (Auto Calibration) - Sony DAR-X1R Operating Instructions Manual

Line Out
Switches on/off the audio output of the LINE 1 –
TV and LINE 3/DECODER jacks.
On
Off
b
Note
When the "TV" indicator appears in the front panel
display, the connected TV speakers are not turned off
even if "Line Out" is set to "Off."
Line 3 Input
Selects the type of audio input signal for speaker
output from the LINE 3 jack.
To enjoy digital sound from the connected
speakers, select "Optical In."
Scart
Optical In
b
Note
Audio signals from the i LINE 3/DECODER jack are
recorded even when "Line 3 Input" is set to "Optical In"
in the "Audio" setup.
Auto Mode Setting
Sets the sound field for AUTO setting (automatic
sound field selection) (page 88).
Focus
Surround
Wide Stage
GB
120
The connected TV speakers are
turned on. You can listen to the
TV sound both through the TV
and system speakers.
The connected TV speakers are
turned off. You can listen to the
TV sound only through the
system speakers.
Inputs an audio signal from the
LINE 3/DECODER jack.
Inputs an audio digital signal
from the LINE 3 DIGITAL IN
(OPTICAL) jack.
"D.IN" appears on the front
panel display.
This mode is ideal for
delivering a realistic surround
effect to a small group of
listeners within a defined area.
This mode will deliver a wide
and impressive sound stage. As
the sound catchment area is
increased, a greater number of
listeners can be accommodated.

Audio (Auto Calibration)

D.C.A.C. (Digital Cinema Auto Calibration) sets
the appropriate surround sound automatically by
adjusting the level, distance, etc.
b
Notes
• Loud test sound is output during the measurement. You
cannot turn the volume down. Give consideration to
children and neighbours.
• The A.CAL MIC jack is for the supplied calibration
mic only. Do not connect other mics as it may cause
damage to the system.
1
Connect the calibration mic to the A.CAL
MIC jack on the rear panel of the
subwoofer.
Set up the calibration mic at ear level using a
tripod, etc. (not supplied). The front of each
speaker should face the calibration mic, and
there should be no obstruction between the
speakers and the calibration mic.
Side view
Calibration mic