Sony DAR-X1R Operating Instructions Manual page 105

3
Press INPUT SELECT on the remote
repeatedly to select "DV."
The front panel display changes as follows:
Programme
position
4
Press REC MODE on the remote repeatedly
to select the recording mode.
The recording mode changes as follows:
For details about the recording mode, see
page 64.
5
Press OPTIONS on the remote to select
"DV Audio Input," and press
select the setting for the audio input.
"Stereo1" (default): Records original sound
only. Normally select this when dubbing a DV
format tape.
"Mix": Records both stereo 1 and 2.
"Stereo2": Records additional audio only.
Select "Mix" or "Stereo2" only if you have
added a second audio channel when recording
with your digital video camera.
You are ready to start dubbing. Select one of
the dubbing methods on the following pages.
6
Adjust the dubbing picture quality and
size.
Before dubbing starts, press OPTIONS to
select "Rec Settings," and adjust the recording
settings (page 69).
z Hint
You can turn off the recorder during dubbing. The
recorder completes dubbing even after being turned off.
b
Notes
• You cannot connect more than one piece of digital
video equipment to the recorder.
• You cannot control the recorder using another device
or another recorder of the same model.
• You cannot record date, time, or the contents of the
cassette memory onto the disc.
• If you record from a DV/Digital8 format tape that is
recorded in multiple sound tracks, such as a tape with
multiple sampling frequencies (48 kHz, 44.1 kHz, or
32 kHz), no sound or an unnatural sound will be output
when playing back the sampling frequency switch
point on the disc.
• In order to use this recorder's "Auto Chapter" setting
(page 106, 107), be sure to correctly set the clock on
your digital video camera before shooting.
• The recorded picture may be momentarily affected or
the start and end points of a programme may be
different from what you have set if the source DV/
. Then,
Digital8 format tape is in any of the following
conditions. In this case, see "Recording from
connected equipment without a timer" (page 74).
– There is a blank space in the recorded portion of the
tape.
– The tape's time code is not sequential.
– If the picture size or the recording mode on the tape
being dubbed changes.
GB
105