Switching The Machine Off; Automatic Response In Case; Of „Overloading; Automatic Vario-Speed Function - Intimus FlashEx 176-4C Operating Instructions Manual

GB
NOTE!
While shredding, repeated reversing (swit-
ching between forward and backward ope-
ration) is normal. This is part of the shredding
process and does not indicate a failure.
Stopping the shredding process manually
The shredding process can be manually stopped at any
time by briefly pressing the stop-button „S" (Fig. 2/3).

3 .6 Switching the machine off

Switch off the unit by turning the mains switch (Fig. 1)
to position „O".
¾ The machine turns off.
3 .7 Automatic response in case of
„overloading"
In case you accidentally overload the shredder, it will
automatically alleviate the problem as follows:
The cutting system becomes jammed. The pilot
ƒ
lamp (Fig. 2/8) lights up.
The cutting system runs briefly in reverse, thereby
ƒ
freeing the material to be shredded.
The cutting system automatically switches back to
ƒ
forward mode.
The machine repeats this process until all the material
has been shredded satisfactorily.

3 .8 Automatic Vario-Speed function

The Vario-Speed optimizes the machine power in the
different working conditions:
The operating speed is automatically increased by
ƒ
up to 50% for small quantities of material.
More power is required at the cutting system for
ƒ
larger quantities of material, and the variable
speed system reduces the working speed automa-
tically in favour of increased power.

3 .9 Manual Vario-Speed function

In addition to the automatic variable speed function,
the operator can also manually select any desired, infi-
nitely adjustable working speed:
Press the vario-speed plus key (Fig. 2/5), in order to
ƒ
increase working speed.
Press the vario-speed minus key (Fig. 2/4), in order
ƒ
to decrease working speed, and to allow for incre-
ased cutting capacity.
Current cutting speed is indicated at the vario-speed
display (Fig. 2/6)
12
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung

3 .10 Emptying the catch basket

NOTE!
Please consult the appropriate recycling servi-
ces in your area to learn how to properly dis-
pose of the shredded material!
1
2
3
1
Door
2 Catch basket
3 Rails
Fig. 5 Catch basket
If the catch basket is full, the motor switches off. The
pilot lamp „Catch basket full" (Fig. 2/9) and the stop-
button „S" (Fig. 2/3) light up.
Proceed as follows to empty the catch basket (Fig. 5/2):
1 . Open the door (Fig. 5/1).
2 . Remove the catch basket with the full bag.
3 . Pull the bag out to its full length, tie it up and seal
it with adhesive tape or cable ties.
4 . Remove the bag and dispose of it with the con-
tents.
5 . Insert an empty bag in the basket.
6 . Insert the basket back into the machine. Place the
basket correctly between the rails (Fig. 5/3) and
push it to the rear wall.
7 . Close the door.
¾ The pilot lamp „Catch basket full" goes out.
¾ The machine is ready for operation.
NOTE!
The machine only runs if the door and the sa-
fety glass are closed!
000095
94626 1 10/17