Led Description - Netis 520G2006M1 User Manual

To reset the AP to the factory defaults, press and hold the Reset button for
more than five seconds. This clears the AP's user settings, including User ID,
Password, IP Address,
configurations will be replaced with the factory default settings)

3.2 LED Description

The following illustration shows the Wireless Access Point front panel:
Number LED
1 PWR
2 CPU
3 LAN Link
4 LAN
Speed
5 LAN
RX/TX
6 Wireless
RX/TX
Wireless Access Point User manual
and Subnet
Figure 2
Light Status
ON This indicator lights green when the
Wireless
otherwise, it is off.
ON The LED will be dark for a few seconds
when the system is started. After that,
the LED will stays green to show the
Wireless AP is working normally. If the
LED stays blink/dark that means the
system failed, you need to contact your
agent or try to reboot the system.
Flashing LAN is connected.
Flashing LAN has Activity (ACT) data being sent or
Received
Flashing LAN has Activity (ACT) data being sent or
Received.
Flashing Wireless has Activity (ACT) data being
sent or Received.
Page 5 of 5
mask. (Warning:
front panel
Description
AP is
your original
receiving power;