Additional Settings For Wireless Client - Netis 520G2006M1 User Manual

5.2 Additional Settings for Wireless Client

If you chose to access the AP via a wireless client, also verify the following:
Step 1: Make sure your PC is equipped with 802.11g or 802.11b wireless
adapter and has appropriate WLAN card driver/utility and TCP/IP installed.
Step 2: Set the wireless adapter to use appropriate TCP/IP settings as
described in previous section.
Step 3: Launch the wireless adapter's provided utility and verify that your
wireless client is configured with these settings:
Operation Mode: Infrastructure
SSID: default
Authentication: Disabled
Encryption: Off
Radio Band: 802.11B/G
If you only finished the wireless settings and didn't configure the wireless
adapter's TCP/IP settings, even your link status indicates a successful
connection with the AP. This connection applies to the "physical" network layer
Wireless Access Point User manual
Figure 13
Page 15 of 15