Wireless Settings; Basic Wireless Settings - Netis 520G2006M1 User Manual

address.
If you change the private IP address and apply the changes, the PC from
which you configure the AP will lose the communication to the AP. To reconnect,
you will need to renew the IP address of the PC or change to an IP address
compatible with the new LAN port IP address.

6.4 Wireless Settings

The Wireless Access Point implements Access Point capability, which connects
wireless clients to a wired LAN. It allows wireless stations to access network
resources and share the broadband Internet connection.

6.4.1 Basic Wireless Settings

The basic settings for wireless networking are set on this screen.
Radio Band: The default setting is mixed mode [802.11B/G]. If you do not
know or have both 11g and 11b devices in your network, then keep the
default in mixed mode. From the drop-down manual, you can select
802.11G if you have only 11G card. If you have only 802.11 B card, then
select 802.11B.
Radio Mode: The Route has 4 modes: AP, Client, WDS, AP+WDS
Booster Mode: Enabled this mode can enhance the throughput of data
transmission.
SSID: The SSID is the network name shared among all points in a wireless
network. The SSID must be identical for all devices in the wireless network.
Wireless Access Point User manual
Figure 23
Page 22 of 22