National Instruments PMC-GPIB Getting Started page 2

Install hardware
4
A. Select an unused PMC slot. You may need to remove the host to access a PMC slot.
B. Insert the PMC-GPIB and screw it into place.
Key
1 Host Face Plate Board
2 3.3 V Keying Hole
3 5 V Keying Hole
4 PMC-GPIB Board
5 Mounting Screws
C. If you removed the host, reinstall it now.
Power on computer, then run NI-488.2 Getting Started Wizard.
5
Power on computer
1 For help installing your hardware, refer to the GPIB Hardware Guide (available on the CD through
Getting Started Documentation).
© 1999–2003 National Instruments Corporation. All rights reserved.
National Instruments TM , NI-488.2 TM , and ni.com
Product and company names mentioned herein are trademarks or trade names of their respective companies.
For patents covering National Instruments products, refer to the appropriate location: Help»Patents in your
software, the patents.txt file on your CD, or ni.com/patents.
1 .
1
TM are trademarks of National Instruments Corporation.
3
2
5
4