Onkyo TX-RZ840 Instruction Manual page 65

„ 7.1.4 Channel System + ZONE SPEAKER (For North American models only)
MAIN ROOM
bm bl
bk 9
2 1
3
6
4
5
8 7
ZONE 2
bo bn
MAIN ROOM: This is an example of combining the top middle speakers at the
front and the rear high speakers at the rear to the 7.1 Channel System. The height
speakers in front can be selected from following 4 types. The height speakers that can
be combined at the rear differ depending on the height speakers used at the front.
❏ Combination example when Top Front Speakers are used at the front (
❏ Combination example when Top Middle Speakers are used at the front (
❏ Combination example when Front High Speakers are used at the front (
❏ Combination example when Dolby Enabled Speakers (Front) are used at the front (
ZONE 2: You can enjoy 2-ch audio in the separate room (ZONE 2) while
performing playback in the main room (where this unit is located). The same
source can be played back in the main room and ZONE 2 simultaneously. Also,
different sources can be played back in both rooms.
• While ZONE 2 playback is being performed, Height 1 speakers installed in the
main room cannot play audio.
Contents
Power amplifier
p38)
p40)
p41)
p44)
Connections
≫
"Speaker Setup" settings during Initial Setup (
„
Speaker Setup
Speaker Channels 7.1.4 ch < >
Subwoofer Yes
Height 1 Speaker Top Middle
Height 2 Speaker Rear High
Zone Speaker Zone 2
Zone 2 Preout Zone 2
Bi-Amp No
Speaker Impedance 6ohms or above
Select how many speakers you have.
When video and audio via HDMI input are output to ZONE 2, set
"1. Input/ Output Assign" - "TV Out / OSD" - "Zone 2 HDMI"
( p153) to "Use" on the Setup menu.
Setup
65
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫ ≫
p181)
• Speaker Channels: 7.1.4 ch
• Subwoofer: Yes
• Height 1 Speaker: Select the type of
height speaker actually installed.
• Height 2 Speaker: Select the type of
height speaker actually installed.
• Zone Speaker: Zone 2
• Zone 2 Preout: Zone 2
• Bi-Amp: No
Next • Speaker Impedance: Set any value (
Setup
≫
p46)