Onkyo TX-RZ840 Instruction Manual page 169

„ 2. Network
Change the settings of the Network function.
• When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default) To assign fixed IP addresses
to each components, you must set "DHCP" to "Disable", assign an address to
this unit in the "IP Address" setting, and set information related to your LAN,
such as Subnet Mask and Gateway.
Setting Item Default Value
Wi-Fi Off(Wired)
Wi-Fi Setup -
Wi-Fi Status -
MAC Address -
DHCP Enable
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Gateway 0.0.0.0
DNS Server 0.0.0.0
Proxy URL -
Setting Details
Connect the unit to the network via a wireless LAN
router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
• When switching between "On" and "Off(Wired)",
stop the Network service. Also, when group
playback is in process, cancel the group
playback once, and then switch the setting.
Configure wireless LAN settings by pressing
ENTER with "Start" displayed.
The information of the connected access point is
displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access
point.
"Status": Status of the connected access point.
Check the MAC address of this unit.
This value is specific to the component and cannot be
changed.
"Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
• If you select "Disable", set "IP Address", "Subnet
Mask", "Gateway", and "DNS Server" manually.
Displays/Sets the IP address.
Displays/Sets the subnet mask.
Displays/Sets the gateway.
Displays/Sets the primary DNS server.
Displays/Sets the proxy server URL.
Contents Connections
≫
Setting Item Default Value
Proxy Port 8080
Friendly Name Onkyo
TX-RZ840
XXXXXX
169
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Displays/Sets the proxy server port number when
you input "Proxy URL".
Change the model name of this unit which is
displayed on the device connected to the network
to an easily recognized name.
1. Press ENTER to display the Edit screen.
2. Select a character or symbol with the cursors,
and press ENTER.
Repeat this operation to input up to 31 characters.
"A/a": Switches between upper and lower cases.
(Pressing MODE on the remote controller also
toggles between upper and lower cases)
"←" "→": Moves the cursor in the arrow direction.
" ": Removes a character on the left of the cursor.
" ": Enters a space.
• Pressing CLEAR on the remote controller will
remove all the input characters.
3. After inputting, select "OK" with the cursors, and
press ENTER.
The input name will be saved.
≫