Onkyo TX-RZ840 Instruction Manual page 119

ZONE B Playback
While performing playback through speakers (ZONE A) connected to the unit, you can enjoy the audio of the same source with the pre-main amplifier, etc. (ZONE B)
( p80) connected to the ZONE B LINE OUT jack at the same time.
Playing Back
Contents Connections
≫
1. Press the Q button on the remote controller and select "Audio" - "Zone B".
• In the following cases, "Zone B" cannot be selected.
– When ZONE 2 is On
– When "2. Speaker" - "Configuration" - "Zone 2 Preout" on the Setup
menu is set to "Zone 2" (
2. Select the audio output destination.
Off: Outputs audio only from ZONE A. "A" on the display of the main unit
lights up.
On(A+B): Outputs audio from both ZONE A and ZONE B. "A"and "B" on the
display of the main unit light up.
On(B): Outputs audio only from ZONE B. "B" on the display of the main unit
lights up.
3. Start play on the AV component.
4. Adjust the sound volume on the pre-main amplifier, etc. of ZONE B.
• When "Zone 2 Preout" is set to "Zone B", and "Audio" - "Zone B" on the Quick
Menu is set to "On (A+B)", the ZONE A output is set as below.
– Sound quality cannot be adjusted.
– "2. Speaker" - "Crossover" - "Double Bass" on the Setup menu (
is fixed to "On".
– The effect for "2. Speaker" - "Distance" on the Setup menu (
disabled.
• If "On(A+B)" is selected as an audio output destination, you can select only
the "Stereo" listening mode for ZONE A when using the 2.1ch speaker layout.
When using a speaker layout of 3.1ch or more, you can select only the "AllCh
Stereo" listening mode.
119
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
p158)
p160) is
≫
p160)