Onkyo TX-RZ840 Instruction Manual page 15

1. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio
signals with a digital optical cable or digital coaxial cable.
2. TUNER AM/FM terminal: Connect the supplied antennas.
3. COMPONENT VIDEO IN jacks: Input AV component video signals with a
component video cable. (Compatible only with 480i or 576i resolution.)
VIDEO IN jacks: Input AV component video signals with an analog video cable.
4. Wireless antenna: Used for WI-Fi connection or when using a BLUETOOTH-
enabled device. Adjust the angles according to the connection status.
5. HDMI OUT jacks: Transmit video signals and audio signals with an HDMI
cable connected to a monitor such as a TV or projector.
6. RS-232 port: Connect a home control system equipped with an RS-232 port.
For adopting a home control system, contact the specialized stores.
7. IR IN port: Connect a remote control receiver unit. (
8. HDMI IN jacks: Transmit video signals and audio signals with an HDMI cable
connected to an AV component.
9. ETHERNET port: Connect to the network with a LAN cable.
10. USB port: Connect a USB storage device to play music files. (
can also supply power (5 V/1 A) to USB devices with a USB cable.
11. AC INLET: Connect the supplied power cord.
12. GND terminal: Connect the ground wire of the turntable.
13. AUDIO IN jacks: Input AV component audio signals with an analog audio
cable.
14. 12V TRIGGER OUT jack: Connect a device equipped with a 12V trigger input
jack to enable power link operation between the device and this unit.
( p84)
15. PRE OUT jacks: Connect to a power amplifier. (
16. SUBWOOFER PRE OUT jacks: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. The same
signal is output from each SUBWOOFER PRE OUT jack.
17. ZONE 3 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplifier or a power amplifier in a separate
room (ZONE 3).
HEIGHT 2 PRE OUT jacks: Connect a power amplifier. (
18. ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplifier or a power amplifier in a separate
room (ZONE 2).
ZONE B LINE OUT jacks: Connect to a pre-main amplifier with an analog
Contents
19. SPEAKERS terminals: Connect speakers with speaker cables. (North
p83)
p96) You
p66)
p66)
15
Connections
≫
audio cable, and simultaneously output audio of the same source as that of
the speakers (ZONE A) connected to this unit.
American models support banana plugs. Use a plug 4 mm in diameter. Y plug
connection is not supported.)
Front Panel≫ Rear
Playback Setup
≫ ≫
Panel≫ Remote≫
≫