Installation; Attaching The Stand (Type One) - Samsung LC49HG90DMNXZA User Manual

Installation

Attaching the Stand (Type one)

― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
― There is a risk of scratch damage if the screwdriver comes in contact with the product surface while fastening the screws. Make sure the screwdriver does not touch the surface.
Caution
Hold the stand neck with both hands, not one hand,
to prevent it from falling off and causing injury.
Caution
Tilt the stand neck to sides to avoid contact with
the screwdriver.
1 7
Assemble the COVER-REAR TOP to the stand neck
as shown in the figure.
1 1
Remove the Cushion Top and Cushion Front, and
then place the Cushion Front on the desk.
1 4
Fasten the screws at the top of the stand neck.
1 8
Rotate the COVER-REAR TOP clockwise.
1 2
Pull the monitor out of the package (two people are
required for this work), and then place the monitor
on the Cushion Front.
1 5
Insert the stand base into the stand neck in the
direction as shown in the figure.
1 3
Place the stand neck on the monitor as shown in
the figure.
1 6
Disassemble the COVER-REAR TOP.
18