Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Erbauer EPHT18-Li
Summary of Contents for Erbauer EPHT18-Li
- Page 1 EPHT18-Li EAN. 3663602418252 ORIGINAL INSTRUCTIONS...
-
Page 2: Product Description
Product description WARNING! Please read all safety warnings carefully and be sure Safety instructions that they are fully understood before handling the tool. Assembly Care & maintenance PRODUCT DESCRIPTION 1. Blade 8. Lock-off button Guarantee 2. Trimmer head 9. On/off switch trigger 3. - Page 3 PRODUCT DESCRIPTION...
-
Page 4: Safety Instructions
SAFETY INSTRUCTIONS GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. -
Page 5: Personal Safety
c. Do n ot expose power tools to rain or wet conditions. Water f. Dress properly. Do not wear loose clothing or jewellery. Keep your hair and clothing away from moving parts. Loose clothes, entering a power tool will increase the risk of electric shock. jewellery or long hair can be caughtin moving parts. - Page 6 f. K eep cutting tools sharp and clean. Properly maintained Do not expose a battery pack or tool to fire or excessive cutting tools with sharp cutting edges are less likely to bind and temperature. Exposure to fire or temperature above 130 °C are easier to control.
-
Page 7: Operation
Check the hedge for foreign objects before operation, e.g. c. Beware of overhead power lines. wire fences. Take care that the cutting device does not come d. Never operate the product while people, especially children, or into contact with wire or other metal objects. pets are nearby. -
Page 8: Maintenance And Storage
• after striking a foreign object; MAINTENANCE AND STORAGE • whenever the product starts vibrating abnormally. a. Disconnect the product from the power supply (i.e. remove the plug from the power supply or the battery pack) and check for f. Ensure that the hedge trimmer is correctly located in a damage after use. -
Page 9: Vibration And Noise Reduction
VIBRATION AND NOISE REDUCTION RESIDUAL RISKS Even if you are operating this product in accordance with all the To reduce the impact of noise and vibration emission, limit the time safety requirements, potential risks of injury and damage remain. of operation, use low-vibration and low-noise operating modes as The following dangers can arise in connection with the structure well as wear personal protective equipment. - Page 10 BATTERY PACK POWER BAR ASSEMBLY The Li-Ion battery pack (12) is equipped with a POWER BAR (11) which is used to give an indication of the battery pack’s remaining charge. Press the POWER BAR button (11) to check battery charge as below. The LED will stay lit for approximately 5 seconds. 76-100% Charge UNPACKING •...
-
Page 11: Intended Use
locked into position and ready for use. PUTTING ON THE SHOULDER STRAP (FIG. G1, G2) Place the shoulder strap(14) over your left shoulder (Fig. G2). Fasten the snap hook on the securing clip on the shaft (Fig. G1). INTENDED USE The length of the shoulder strap can be adjusted. -
Page 12: Care And Maintenance
OVERLOAD, TEMPERATURE AND CHARGING PROBLEM PROBLEM TOOL / BATTERY POSSIBLE SOLUTION CARE & MAINTENANCE STATUS CAUSE Overload Product suddenly Extremely high Relieve the load immediately, protection stops torque, binding and reset the tool by switching off stalling situations, and back on again. WARNING! Always switch the product off, remove the battery pack and overloading of the... - Page 13 Before and after each use, check the product and accessories (or attachments) for wear and damage. If required, exchange them for new ones as described in this instruction At Erbauer we take special care to select high quality materials and use manufacturing manual. Observe the technical requirements.
-
Page 14: Technical Specifications
Max. cutting capacity: 20mm RATING LABEL EXPLANATION Angle at which the motor can be set: ±45° & ±90° EPHT18-Li = MODEL NUMBER E = ERBAUER Max. length of the tool: 2.9m PHT = POLE HEDGE TRIMMER Weight (without battery): 4.2kg... -
Page 15: Declaration Of Conformity
United Kingdom Declare that the product: Objects thrown by the product could Erbauer 18V Li-Ion pole hedge trimmer EPHT18-Li hit the user or other bystanders. Switch the product off and remove Serial number 000001-999999 the battery pack to disconnect... - Page 16 Manufacturer • Fabricant • Producent • Hersteller • Producator • Fabricante: Kingfisher International Products Limited 3 Sheldon Square London W2 6PX United Kingdom www.kingfisher.com/products DISTRIBUTOR: B&Q plc, Chandlers Ford, Hants, SO53 3LE United Kingdom www.diy.com Screwfix Direct Limited, Trade House, Mead Avenue, Yeovil, BA22 8RT, United Kingdom www.screwfix.com...
Need help?
Do you have a question about the EPHT18-Li and is the answer not in the manual?
Questions and answers