Wep Encryption - ZyXEL Communications 760559122614 User Manual

Note: If you do not enable any wireless security on your NBG-418N v2, your network is
accessible to any wireless networking device that is within range.
Figure 43 Network > Wireless LAN > General: No Security
The following table describes the labels in this screen.
Table 18 Network > Wireless LAN > General: No Security
LABEL
Security Mode
Apply
Reset

6.4.2 WEP Encryption

WEP encryption scrambles the data transmitted between the wireless stations and the access points
to keep network communications private. It encrypts unicast and multicast communications in a
network. Both the wireless stations and the access points must use the same WEP key.
Your NBG-418N v2 allows you to configure up to four 64-bit or 128-bit WEP keys but only one key
can be enabled at any one time.
In order to configure and enable WEP encryption; click Network > Wireless LAN to display the
General screen. Select Static WEP from the Security Mode list.
Figure 44 Network > Wireless LAN > General: Static WEP
Chapter 6 Wireless LAN
DESCRIPTION
Choose None from the drop-down list box.
Click Apply to save your changes back to the NBG-418N v2.
Click Reset to reload the previous configuration for this screen.
NBG-418N v2 User's Guide
66