Panasonic MC-CG885 Operating Instructions Manual page 22

D-16
22
D - MAINTENANCE AND SERVICING
Exhaust fi lter
D-16 Exhaust filter is installed in the rear side of the vacuum
cleaner.
This filter retains small dust particles which may be
present in the expelled air.
It is advisable to change the exhaust filter when it
becomes dirty.
To change the exhaust filter, hold the exhaust cover (as
illustrated) and pull it out.
After changing the filter, set the exhaust cover to original
position (as illustrated).
IMPORTANT: Never use the vacuum cleaner without the correct
filters properly installed. Failure to do so may result
in damage to the motor.
What to do if your cleaner does not work
Check that the vacuum cleaner is correctly plugged in and that
the socket outlet is working.
This vacuum cleaner has a thermal protector which automatically
trips to protect the vacuum cleaner from overheating.
If the thermal protector device has operated, wait until it resets
automatically after approximately 60 minutes. If after having
checked the above mentioned points, the vacuum cleaner does
not work, take it to an Authorized Service Centre to be repaired.
What to do when the suction performance
reduces
• Stop the vacuum cleaner and unplug from the socket outlet.
• Check whether the wands, hose and accessories are blocked
or not.
If they are blocked, remove the obstruction.
• Check whether the paper dust bag is full. If it is full, replace it .
• Check whether the pre-motor filter or exhaust filter is blocked
with dust.
If they are blocked, clean them out or replace them.