Beep Tone - Panasonic NE-2157R Operating Instructions Manual

X To Release Program Lock:
PAD
1 Open the door and leave it open.
The oven lamp will turn on, and "0" will appear.
2 While pressing Stop/Reset pad, press Prog pad until "PROG" and
STOP/
"P" appear. (more than five seconds)
PROG
RESET
"PROG" and "P" will appear.
In Program Unlock mode:
• Oven reverts to a two-touch operating mode (Number/Memory pad + Start pad).
• Repeat and interrupt feature are operational.
• Number/Memory pads can be programmed.
• Tone loudness control and length control are operational.
F. BEEP TONE
The loudness of beep tone and the length of beep tone
at the end of heating cycle can be set.
There are four levels of the loudness. The level is
indicated by a number followed by the word "bEEP".
3bEEP = loudest
2bEEP = middle
1bEEP = quietest
0bEEP = silent
X To Select Loudness Level and Length "3 beeps":
Example: To select loudest beep tone
PAD
1 Open the door and leave it open.
The oven lamp will turn on and "0" will appear.
2 Press Prog pad.
PROG
3 Press Number/Memory pad "0" once.
0
The tone will sound at its loudness level and the loudness level "3"
followed by the word "bEEP" will appear. "PROG" will start to blink and
1st Stage Heating Indicator "1" (the length of beep tone "3 beeps") will
be indicated.
Note: Repeating to press the pad "0" will lower the loudness all the way
Press Prog pad.
4
PROG
"PROG" will stop blinking. That means that you have completed
program.
Three seconds later, "0" will appear.
• Close the door. One minute later, Digital Display Window will go blank.
How to Operate
INSTRUCTION
to silent. (3 bEEP –– loudest, 2 bEEP –– middle,
1 bEEP –– quietest, and 0 bEEP –– silent)
INSTRUCTION
There are two options of the length of beep tone at the
end of heating cycle. The length is indicated by 1 st or
2 nd Stage Heating Indicator.
1 = 3 beeps
2 = short beeps for 60 seconds
The loudest level and 3 beeps are preset at the factory.
- 12 -
DIGITAL DISPLAY WINDOW
PROG
DIGITAL DISPLAY WINDOW
PROG
1
PROG
1