To Read Cycle Counter; To Select Beep Tone Options (On/Off Of Beep Tone); To Lock Program Of Memory Pad - Panasonic ne-1037 BTQ Service Manual

NE-1027 / NE-1037
OPERATION
7. Close the door, display will
return blank after 1 minute.
2.6.

To Read Cycle Counter

OPERATION
1. Open the door and leave it
open.
2. While pressing Stop/Reset
pad, press Power Level
pad. eg. 0010 means the oven
has been used 1,000 times.
9999 means the oven has
been used 999,900 times.
3. 2 seconds later, the display will
return to "0".
2.7. To Select Beep Tone Options
(ON/OFF of Beep Tone)
OPERATION
1. Open the door.
2. Press Prog pad.
3. Press 0 pad.
4. Press 0 pad again.
(No beep tone setting)
5. Press Prog pad again.
You have completed
programming the beep tone
option.
6. 2 seconds later, the display will
return to "0".
DISPLAY
2.8.
1. Plug the power supply cord into
wall receptacle.
- Display must be blank -
2. Press and hold in the Prog
DISPLAY
pad until the display shows "P"
and "L".
(Approximately 6 seconds)
NOTE: When oven is in
"program lock mode", display
will not show anything and
remain blank.
2.9.
1. Plug the power supply cord into
wall receptacle.
DISPLAY
2. While pressing and holding the
Stop/Reset
hold in the Prog
the display shows "P".
(Approximately 6 seconds)
NOTE:
When oven is in "program
unlock mode", display will not
show anything and remain
blank.
8
To Lock Program of Memory
Pad
OPERATION
To Release the Memory Pad
Program Lock
OPERATION
pad, press and
pad until
DISPLAY
DISPLAY