Options Setting; Starting A Cycle; Interruption Of A Program; Changing A Program - Electrolux EWF14113S User Manual

5.3 Options Setting

If you want your laundry to be spun or
1.
use temperature different from the one
proposed by the washing machine,
pess the Spin "
temperature " " touchpads
repeatedly to change the spin speed
and temperature.
Press the option touchpads, if you
want your laundry to be washed with
special functions.
NOTE
-
Different functions can be combined
which is dependent on the program
selected.
-
If an option is not compatible with the
wash program selected, the message
"Not Available" will flash on display
along with buzzer sound.
2.
If you want to adjust washing time,
press the "Time Manager (
touchpad repeatedly to increase or
decrease washing time. See Time
Manager guide on page 13.
If you want to define the end of the
washing program, press the "Delay End
( )" touchpad repeatedly to choose
your washing machine working time.

5.4 Starting A Cycle (

To start a program, press the
Start/Pause touchpad. The
corresponding pilot light will stop
flashing and a default program duration
will be displayed on the screen.
NOTE
-
If you press any touchpad while a
program is operating, the message
"Not Available" will flash on display
along with buzzer sound. (except
Start/Pause touchpad and On/Off
button)
After approx. 15 minutes from the
start of a program:
- The appliance will automatically
adjust the selected program duration
according to the type and size of the
load.
- The display will show adjusted
program duration.
" and the
)"
)

5.5 Interruption Of A Program

-
To pause, press Start/ Pause. The
indicator will start flashing.
-
Press the Start/Pause again. The
program will continue.

5.6 Changing A Program

Changing a running program is possible
only by switching off the appliance.
-
Press the "On/Off" button to cancel
the program and to turn off the
appliance.
-
Press the "On/Off" button again to
start the appliance.
Now you can set a new wash program
and change any available options. Press
Start/Pause to start the new program.
The appliance will not drain the
water (except programs; Refresh,
Spin, Rinse + Spin, Tub Clean).

5.7 Changing The Options

It may be possible to change some of the
options after a wash program has started.
Press the touchpad Start/Pause. The
1.
indicator will start flashing.
If available change the options that
2.
you wish.
Press Start/Pause again. The program
3.
will continue.

5.8 Opening The Door

While a program or the Delay End is
operating, the appliance door is locked
and the display shows the indicator "
First, set the machine to PAUSE by
pressing the "Start/Pause" touchpad. Wait
until the door lock indicator "
then the door can be opened.
If the door lock indicator "
disappear, this means that the machine
is already heating and the water level is
above the bottom edge of the door or the
drum is turning. In this case the door
CAN NOT be opened. If you need to
open it, you must drain the water to open
the door.
In case of emergency please
refer to "Emergency door
opening" on page 28.
ENGLISH 17
".
" goes off,
" does not