Changing The Recording Mode Of The Motion Picture - Panasonic VDR-D105 Operating Instructions Manual

Screen indications in the disc recording mode
A Remaining time left for recording
(When the remaining time is less than 1 minute, [R 0h00m]
flashes red.)
B Recording mode
C Recording time elapsed
≥ While motion picture recording is in progress, do not
disconnect the battery or AC adaptor. If you do, a
repair disc message may be displayed when the
power is turned back on. (l 83, About recovery)
Immediately after recording finishes the ACCESS/PC lamp lights. While it lights, the disc is
rotating and disc information is being recorded. If you run while holding the unit or swing it, the
recorded images may be distorted so do not strongly shake or cause impact to it.

Changing the recording mode of the motion picture

Press the MENU button, then select [
REC MODE] # desired item and press the joystick.
[
Recording modes and recordable time available for the motion picture
This unit records in VBR. VBR is an abbreviation for Variable Bit Rate. VBR recording automatically
varies the bit rate (amount of data in a fixed time) depending on the subject being recorded. This
means if a subject with sharp movements is recorded, the recording time is reduced.
Recording mode
XP
(High quality)
SP
(Normal)
LP
(Long play)
≥ Mosaic-pattern noise may appear on a playback
image in the following cases.
– When there is a complicated pattern in the
background
– When the unit is moved too much or too fast
– When a subject with sharp movements has been
recorded
(Particularly if [ REC MODE] was set to [
during recording.)
BASIC] #
Recordable time
(on single side)
Approx. 18 min
Approx. 37 min
Approx. 75 min
]
LP
Recording motion pictures
SP 0h00m10s 0h00m10s 0h00m10s
A
R 0h02m R 0h02m R 0h02m
B
C
Image quality prioritized
Recording time prioritized
37
LSQT1040