Setup; Power Supply; Charging The Battery - Panasonic VDR-D105 Operating Instructions Manual

Diga dvd palmcorder® multicam™ camcorder vdr-d105 operating manual (english, spanish)
Table of Contents

Advertisement

Setup

Power supply

Power supply

Charging the battery

When this unit is purchased, the battery is not charged. Charge the battery before using this unit.
≥ If the DC cable is connected to the AC adaptor, then the battery will not charge. Remove
the DC cable from the AC adaptor.
1 Connect the AC cable to the AC adaptor and the
AC outlet.
2 Put the battery on the battery mount by aligning
the mark, and then securely plug it in.
≥ The output plug of the AC cable is not completely connected to the
AC adaptor jack. As shown in A, there is a gap.
∫ Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged (discharged excessively). In a while, the lamp will light up
and normal charging will start.
When the battery temperature is excessively high or low, the CHARGE lamp flashes and
the charging time will be longer than normal.
≥ Battery charging time (l 23)
≥ We recommend using Panasonic batteries.
Fitting the battery
Push the battery against the battery holder and slide
it until it clicks.
Removing the battery
While sliding the BATTERY RELEASE lever, slide the
battery to remove it.
≥ Hold the battery with your hand so it does not fall.
≥ Be sure to turn off the power on this unit and check
that the status indicator and the access lamp are
both off before removing the battery.
22
LSQT1040
≥ If you use other batteries, we cannot guarantee the
quality of this product.
A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents