Setting Date And Time - Panasonic VDR-D105 Operating Instructions Manual

Setting date and time

If the screen shows the incorrect date/time, then adjust it.
¬ Rotate the mode dial to select
1 Press the MENU button, then select [
CLOCK SET] # [YES] and press the joystick.
[
2 Move the joystick left or right to select the item to be
set. Then, move the joystick up or down to set the
desired value.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 12-hour system is used to display the time.
3 Press the joystick to enter the selection.
≥ After pressing the MENU button to finish the setting, check the date and time display.
≥ The clock function starts at [00] seconds.
∫ Changing the display style
Press the MENU button, then select [
[ DATE FORMAT] # desired display style and press the joystick.
Display
Y/M/D
style
Screen 3:30 PM
display 2006.12.15
∫ Changing the date and time display style
Press the MENU button, then select [
# desired display style and press the joystick.
[DATE] [D/T]
12.15.2006
12.15.2006
≥ The date and time function are driven by a built-in
lithium battery.
≥ Make sure to check the time before recording.
≥ If [0] or [- -] is indicated when this unit is turned
on, then the built-in lithium battery runs down. After
charging the battery using the steps below, set the
clock.
Connect the AC adaptor to this unit or place the
battery on this unit, and the built-in lithium battery
will be recharged. Leave this unit as is for approx.
24 hours, and the battery will save the date and time
for approx. 6 months. (Even if the OFF/ON switch is
set to OFF, the battery is still being recharged.)
.
SETUP] #
M/D/Y
3:30 PM
12.15.2006
SETUP] # [
[OFF]
3:30 PM
BASIC] #
D/M/Y
3:30 PM
15.12.2006
DATE/TIME]
Setting date and time
33
LSQT1040