Sony XPERIA ACE II Instruction Manual page 154

❖ Information
Do not change the MCC/MNC. If you change them to
･
the values other than the default (440/10), the access
point will not be displayed on the APN screen. If the
set access point is not displayed,
[Reset to default], or tap
point again.
It is recommended that you use the access point that
･
is registered by default as it is.
Initializing an access point
■
From the Home screen,
1
u
[Settings] [Network & internet]
[Mobile network]
[Access Point Names].
u
[Reset to default].
2
u
in Step 2 Tap
and then set the access
u
u
u u
[Advanced]
Airplane mode
In this mode, the functions of using radio
wave transmissions such as calling, accessing
to the Internet (including sending/receiving
mails), etc. are disabled.
From the Home screen,
1
u
[Settings] [Network & internet].
of "Airplane mode".
2
appears on the status bar.
･
❖ Information
Even if Airplane mode is ON, Wi-Fi, Bluetooth
･
function and NFC/Osaifu-Keitai function can be
turned on. Do not turn on these functions in a place
where the use of radio wave is prohibited.
Depending on Bluetooth device that is currently
･
connected, communication may be maintained
even if Airplane mode is ON.
Using tethering function
Use tethering function which allows wireless
LAN devices, USB devices, or Bluetooth
devices to access the Internet via the terminal
as a modem.
u
Settings
152