Changing the speaker setting to suit your speakers
When connecting with an HDMI cable to an amplifier, use the following settings on this
unit if you cannot set the speaker delay effect on the amplifier.
Front (L)
L
m s
Exit
0.0
Exit
LS
— Surround —
(LS)
Speaker presence and size (a)
1. Press [3 4 2 1] to select an item and press [ENTER].
2. Press [3 4] to change the content and press [ENTER].
Icon examples:
Surround speaker (LS)
LS
Large
≥ Large: Select when the speaker supports low-frequency (under 100 Hz) reproduction.
≥ Small: Select when the speaker does not support low-frequency reproduction.
If the subwoofer is set to "No", the front speakers will automatically be set to "Large". (In
this case, we recommend connecting a speaker that can reproduce bass below
100 Hz.)
Center
Front (R)
R
C
SW
m s
RS
0.0
(RS)
Subwoofer
LS
Small
No
Delay time (b)
(Effective when playing multi-channel audio)
If either distance c or e is less than d, find the difference in the relevant table and
change to the recommended setting.
1. Press [3 4 2 1] to select an item and press [ENTER].
2. Press [3 4] to change the content and press [ENTER].
:
Recommended
placement
L
R
C
SW
RS
LS
To finish the speaker setting
Press [3 4 2 1] to select "Exit" and press [ENTER].
c Center speaker
Difference
Setting
⁄
Approx. 34 cm (1
1
feet)
1.0 ms
10
⁄
2.0 ms
Approx. 68 cm (2
1
feet)
5
⁄
Approx. 102 cm (3
3
feet)
3.0 ms
10
⁄
Approx. 136 cm (4
2
feet)
4.0 ms
5
⁄
Approx. 170 cm (5
1
feet)
5.0 ms
2
e Surround speakers
Difference
Setting
⁄
Approx. 170 cm (5
1
feet)
5.0 ms
2
Approx. 340 cm (11 feet)
10.0 ms
⁄
Approx. 510 cm (16
1
feet)
15.0 ms
2
21