midiplus PianoEngine Owner's Manual page 6

3.1 Sign Light:
When data exchange between devices, the light flashes.
3.2 Monitor:
LCD displays data values such as tone number, drum number, channel value,
volume value, preset combination, and remaining power.
3.3 Preset A,B &C:
Press these buttons, light up. The parameters (volume, tone, etc.) will change
to the preset A, B or C that you set before. And the display will show the
current of preset combinations.
3.4 Drum mode:
Press [Drum] button, light up and enter to drum mode. Adjust the drum
number by rotating the wheel; the display shows the current number, drum
speed and drum volume value. Short press the wheel to control play and stop.
3.5 Sound mode:
Press [Sound] button, light up and enter the sound mode. Adjust the sound
number by rotating the wheel; the display shows the current number, channel
value and volume value.
3.6 Channel:
In the sound mode, when you press [Channel] button, the button lights up,
and the channel is adjusted by rotating the wheel (except 10); the display
shows the current channel value.
3.7 Volume:
Press [Volume] button, light up, and the volume value is adjusted by rotating
the wheel; the display shows the current volume value.
3.8 Set:
Press [Set] button, light up, and then press [Shift] button to select reverb/
chorus/ continuous/ translation/ modulation, adjust the value by rotating the
wheel; the display shows the current value.
3.9 Save:
Press [Save] button, light up, after 2 seconds, the light is off, the current
parameter is saved to the current preset combination (A/B/C), and the display
shows the save status.
3.10 Shift:
MIDIPLUS Co, Ltd. 6