Installing And Removing The Battery - Canon MARK II EOS 5D Instruction Manual

Installing and Removing the Battery

Installing the Battery
Load a fully charged Battery Pack LP-E6 into the camera.
Only the Battery Pack LP-E6 can be used.
Removing the Battery
After opening the battery compartment cover, be careful not to swing it back
further.
Otherwise, the hinge might break.
26
Open the battery compartment
1
cover.
Slide the lever as shown by the arrow
and open the cover.
Insert the battery.
2
Insert the end with the battery
contacts.
Insert the battery until it locks in
place.
Close the cover.
3
Press the cover until it snaps shut.
Open the cover and remove the
battery.
Press the battery release lever as shown
by the arrow and remove the battery.
To prevent short circuiting, be sure to
attach the protective cover to the battery.