Table of Contents
Advertisement
mounnng strategy. To achieve the correct PCB Manng height Movidius recommends the use of the following
connector type for MV0212 daughtercard designs:
Manufatturer
Part umber
Samtec
LSHM-120-06.0-L-DV
Table 14: Retommended Daughtertard Connettor Spetiftaton
For diagnosnc or debug purposes Samtec also produce a cable that is companble with this connector type.
Manufatturer
Part umber
Samtec
HLCD-20-09.80-BD-TD-2
Table 15: Retommended Daughter tard Connettor Spetiftaton
9.4
Connettor Pin umbering Conventon
The MV0212 design uses a common connector for each daughtercard interface.
This connector is a hermaphrodinc connector and as such it is important that a common convennon is
adopted to ensure the correct connecnon of daughtercard signals.
The following convennon has been adopted by Movidius for the MV0212 design:
In order to keep the schemanc symbol the same for both motherboards and daughtercards
Movidius opted to use diferent footprints on motherboard and daughtercard PCBs.
To keep things easy for eexternal daughtercard designers, the ofcial pinout (as described in the
Samtec datasheet) is used for all daughtercard layouts.
As such only the Movidius MV0212 motherboard uses this non-standard footprint.
To ensure companbility daughtercard designers should only need to apply the following two
steps:
1. Use the same schemanc symbol for daughtercard designs as in the MV0212 Schemancs
2. Follow the default layout footprint guidelines as documented by Samtec.
The pin numbering will then match that of the schemanc symbol, e.g. MIPI_PHY0_CLK_N goes to
pin 3 for camera daughtercard designs.
Intel Movidius Confdennal
Distributor
Farnell
Distributor
Samtec Direct
32
User Manual (MV0212-UM-1.2)
Part umber
2433941
Part umber
N/A
Advertisement
Table of Contents
