Table of Contents
Advertisement
Available languages
Available languages
IF Channel
Freq.
1210
Press Exit to save settings and return to the previous screen and continue with
the channel search as shown in paragraph 8.1.2.
CAUTION
If two receivers are connected in cascade to the antenna signal via the LNB OUT
pass-through connector, they can not operate simultaneously. When a receiver
is switched on, the other must be placed in stand-by (not supplied with the
tuner) and vice versa
To connect multiple receivers to a SCR system, do not use the connection
through antenna receiver, but use a suitable divider external signal.
7.3 System DiSEqC 1.0/1.1
The DiSEqC 1.0 / 1.1 protocol has been developed for receiving multiple
satellites via antenna systems with multiple converters, also known as multi-
feed, and up to four different orbital positions for the DiSEqC 1.0 and up to
sixteen for DiSEqC 1.1.
7.3.1 Antenna e satellite configuration
From the Antenna Set Up perform the following options:
16. Satellite : chose the desired satellite. Highlight the satellite and press OK
to confirm and press ►.
17. LNB type : inferior/superior frequency of the local oscillator of the
converter
18. LNB supply : LNB supply for switching between horizontal and vertical
polarization
19. 22KHz : signal at 22KHz switching between high and low band
20. Tone burst : none.
21. DiSEqC 1.0 o DiSEqC 1.1 : select the LNB number based on its aerial
system (i.e. Dual-feed: Hot Bird 13°E on LNB1 and Astra 19.2°E on LNB2)
22. Motor: none.
NOTE
Repeat the above procedure for each satellite for which you want to perform a
channel search
1
2
1420
3
4
1680
2040
ENGLISH
15
Advertisement
Table of Contents
