Tele System SOUND LED08 Manual page 42

7.1.1 Antenna and satellite configuration
From the Antenna setup menu make the following choices:
Satellite : Satellite choice of interest. Highlight the Satellite confirm by
7.
pressing OK and press ►.
LNB type : Type of converter (Low Noise Block converter - LNB) associated
1.
to the chosen satellite. For common satellite systems used in Italy, The
Universal (9750/10600) is used.
LNB supply : LNB power supply for switching between horizontal and
2.
vertical polarization. Generally it must be maintained active (13 / 18V). Its
inactivation is rather useful when you realize IF-IF distribution plants (for
Expert users).
3. 22KHz : 22KHz signal switching between high and low band
Tone burst : none
8.
DiSEqC 1.0 : none
9.
10. DiSEqC 1.1 : none
11. Motore: none
7.1.2 Channel search for satellite
After setting the configuration, to search channels on the chosen satellite press
the BLUE button Scan and define the following parameters in the Channel
Search dialogue window:
12. Scan type : scanning mode following the transponder database (default
option) or blind-scan frequency steps (Blind-Accurate option) or via
network (network option) that scans the active transponders.
13. Channel type : choose free to air channels to only search for free
channels (recommended), Encrypted only for encrypted channels or All to
scan both types.
14. Service type : choose DTV to only search for TV channels, Radio to only
search for radio All
15. Press OK to start scanning.
7.2 SCR/Unicable System
For single-antenna converter (LNB) / satellite installations with SCR / Unicable
technology for the distribution of satellite signals to multiple points of use
(receivers) with a single cable, you must set the LNB type with the Unicable
value and enter the appropriate configuration:
Canale IF : User number corresponding to the channel assigned to the
TV/Receiver regarding the SCR system. Each receiver connected to the same
system must use a different IF channel.
Central Freq. : main frequency of the band/SCR channel assigned to the user.
Typical values for interfacing with other receivers/tuners are
14