Tele System SOUND LED08 Manual page 41

ENGLISH
Yellow button (Move): to move a channel, select the channel you want to move,
press the Yellow button, use the arrow keys to move the channel to the desired
position or enter the desired position number, then press OK to confirm.
6.4 Favorites list
You can create a favorite channels list for DTV channels (terrestrial signal):
Once the option Program Edit and the channel you want to add to the Favourites
list has been selected, press the FAV button; Repeat for each channel you want
to add.
After you create the list, to access it, simply press the FAV button and select the
channel with the arrow keys UP/Down and OK to confirm.
You can later remove one or more channels by performing the same procedure,
selecting the channel you want to delete, and pressing the FAV button.
7 Satellite mode
To activate the digital channel reception mode, press the Source button, select
Satellite.
You can scan the frequencies available with your satellite antenna system,
automatically searching for all the satellite channels from the first installation
(see paragraph 6.8) or through an automatic scanning available in the Channels
menu.
Antenna setting: the basic settings to allow the use of the TV with a single
Universal LNB (Low Noise Block converter) system (commonly used for satellite
systems in Italy); in the event your system is done with a different configuration,
you must appropriately change the antenna settings.
ATTENTION!!!
The wrong antenna configuration can result in the failure to load some or all
channels. If you do not know the characteristics of your antenna system and/or
are unable to properly configure the receiver yourself, you may want to consult
a professional installer for advice. The power and signal quality indicators refer
to the first transponder of the chosen satellite list.
Changing the DiSEqC 1.0 / 1.1 parameters, DiSEqC 1.2 / DiSEqC 1.3 , you will get
three different configuration modes.
7.1 Simple installation
For the single inverter antenna (LNB)/satellite with direct connection between
the TV and antenna, they DiSEqC commands or other special communication
protocols are not used.
13