Gared Hoopmaster LT Installation, Operation And Maintenance Instructions

Portable backstop

Hide thumbs Also See for Hoopmaster LT:

Installation, operation and maintenance instructions (12 pages)

Table Of Contents

Quick Links

Download this manual

Hoopmaster LT Portable Backstop

Model 9305

Installation, Operation and Maintenance Instructions

Please read all instructions before attempting installation or operation of these units

SAVE THESE INSTRUCTIONS FOR FUTURE USE

Publication No.

551754092 revA

03/20/19

Table of Contents

Need help?

Do you have a question about the Hoopmaster LT and is the answer not in the manual?

Questions and answers

Summary of Contents for Gared Hoopmaster LT

Page 1 Hoopmaster LT Portable Backstop Model 9305 Installation, Operation and Maintenance Instructions Please read all instructions before attempting installation or operation of these units SAVE THESE INSTRUCTIONS FOR FUTURE USE Publication No. 551754092 revA 03/20/19...
Page 2: Table Of Contents
Hoopmaster LT Portable Backstop Table of Contents Section Page No Specification Item List Introduction Cautions and Warnings Assembly and Setup Unit Operation Maintenance...
Page 3: Specification
Hoopmaster LT Portable Backstop Specification Model 9305...
Page 4: Item List
Hoopmaster LT Portable Backstop Parts List Item Part Number Description BB72G50 72" X 42" X 1/2" GLASS BACKBOARD 2000 COLLEGIATE BREAKAWAY GOAL PMCE BANK PADDING 556404281 UPPER BRACE - BB BOARD 556404284 STRUT RETAINING WELDMENT 556404286 ATTACHING PLATE M802-10-160 HEX BOLT, M10 x 160...
Page 5: Introduction
Hoopmaster LT Portable Backstop Introduction Thank you for purchase of a Gared Sports Hoopmaster LT Portable backstop. To ensure that our equipment will provide years of use to you, we are including this installation, operation and maintenance of your portable backstop.
Page 6: Cautions And Warnings
Hoopmaster LT Portable Backstop Safety Read and understand the following warnings to prevent possible personal injury and potential damage to the equipment during assembly, setup, and operation. Before proceeding with assembly, read all instructions and assembly procedures. Make sure all parts have been received and are not damaged.
Page 7: Assembly And Setup
Hoopmaster LT Portable Backstop ASSEMBLY IMPORTANT NOTE: Before proceeding to the first step, make sure at least three individuals are available to assist with the mounting of the backboard to the unit. A minimum of two, preferably three, individuals is required for safe assembly of the backboard to the unit.
Page 8 Hoopmaster LT Portable Backstop 2. Attach the backboard brace yokes to the brackets on top half of board, using M10 x 40 hex head bolts with flat washers, lock washers, and nuts. Secure braces to bracket on main arm with M10 x 50 hex bolt, lock washer and nuts. Place bottom support bracket on and tighten in place with (2) M10 x 160 hex head bolts with washers, nuts and lock washers.
Page 9 Hoopmaster LT Portable Backstop 4) To set the unit the floor pads must be locked in place. Stepping on them can do this. The pads are found at all four corners. Leveling can be done with the adjustment screw. ADJUSTMENT SCREW SETTING FLOOR PADS 5) Using masking tape and pencil, Mark the location of the center of the court 4’-0”...
Page 10 Hoopmaster LT Portable Backstop 7) To level the backboard in the horizontal plane, loosen, (do not remove), the two goal carriage bolts and the two 3/8 bolts at the bottom of the board mounting bracket that attach the bracket to the backboard. Level the board and tighten all four bolts securely.
Page 11 Hoopmaster LT Portable Backstop 12) Mark the floor for the locator pins located at the front inside corners of the base unit. 13) Install the locator bushings in the floor, recessed flush with the floor playing surface. 14) Mark and install the rear floor anchors to match the rear tie down plate, item 13, as shown using ½-13 hex bolts into the floor...
Page 12 Hoopmaster LT Portable Backstop 14) Raise the unit to the playing position and insert the safety pin into the sliding locking bar. 15) Install the Upright pad, item 23, to the front upright using bracket, item 28, and ¼-20 pan head screws.
Page 13: Unit Operation
Hoopmaster LT Portable Backstop Operation 1. Before operating the unit, read all caution, warning, and information labels. 2. To raise the unit from the stored position. a. Make sure the unit is in the correct position on the court and drop locator pins to engage bushings in the floor.
Page 14: Maintenance
Hoopmaster LT Portable Backstop Maintenance 1. General inspection of equipment when used should be performed to ensure no catastrophic failures have occurred during the course of use between yearly inspections. 2. It is recommended that yearly inspections be conducted to determine if any bolts or other hardware has become worn or loosened.
Page 16 Gared Holdings, LLC Performance Sports Systems Gared Sports 9200 E. 146 Street 9200 E. 146 Street Noblesville, IN 46060 Noblesville, IN 46060 800-848-8034 800-325-2682 www.perfsports.com www.garedsports.com...

This manual is also suitable for:

9305