Related Manuals for Gared 7200 Series
Summary of Contents for Gared 7200 Series
- Page 1 Model: 7200 series Collegiate Volleyball System Installation, Operation, and Maintenance Instructions Please read all instructions before attempting installation or operation of these units SAVE THESE INSTRUCTIONS FOR FUTURE USE UBLICATION 601751793 09/30/2019...
-
Page 2: Table Of Contents
7200 Collegiate Volleyball System Table of Contents Section Page No. Introduction Parts List by Sub-Assembly Specifications Floor Sleeve Installation Floor Cover Installation Post and Net Installation Instructions 9-11 Maintenance Check Sheet... -
Page 3: Introduction
Bill of Materials are present prior to beginning assembly and setup. Please do not substitute for factory parts. Please contact the PSS or Gared Sports customer service department and allow them to determine if substitute parts are acceptable. - Page 4 7 2 601651739 DOUBLE FOOTMANS LOOP 8 1 2004‐22‐01 FOOTMANS LOOP 9 1 1282‐30‐00 5/16" UNIVERSAL SNAP LINK 10 1 2044‐31‐00 DECAL, ATTN CONSUMER 11 2 121974127 DECAL, GARED TALL BLACK 12 2 121974128 DECAL, "G" 6000 & 7200 POST 13 4 234‐10‐32‐8Z SCREW, MACH PAN HD PHIL 10‐32 UNF X 0.5 14 2 509‐5‐18‐10 HEX SOCKET BUTTON HEAD 5/16‐18 X 0.625 15 2 544‐5‐18 HEX JAM NUT, NYLON LOCK 5/16‐18 7210 END POST Item QTY Part Number ...
-
Page 5: Specifications
7200 Collegiate Volleyball System MODEL 7200 COLLEGIATE VB SYSTEM MODEL 7205 COLLEGIATE VB SYSTEM less SLEEVES AND COVERS... - Page 6 7200 Collegiate Volleyball System MODEL 7202 COLLEGIATE TWO COURT VB SYS MODEL 7207 COLLEGIATE TWO COURT VB SYS less SLEEVES AND COVERS...
-
Page 7: Floor Sleeve Installation
1. Mark (2) spots on the floor exactly 36 feet apart (refer to most recent set of architectural prints for exact locations within the gym). These represent the CENTERS of each sleeve installation. If sleeves are to be more or less than 36 feet apart, contact a PSS or Gared representative for information regarding this alteration. - Page 8 7200 Collegiate Volleyball System Installation Instructions for Ground Sleeves...
-
Page 9: Floor Cover Installation
7200 Collegiate Volleyball System Counterbore Details and Floor Cover Installation... -
Page 10: Post And Net Installation Instructions
7200 Collegiate Volleyball System Post and Net Installation Instructions 1. Lift and rotate the floor covers out of the way. Insert the Winch Post and End Post. 2. Lay out the net in the approximate position between the two posts. 3. - Page 11 7200 Collegiate Volleyball System b. The net cable tension does not make the net play livelier as the net can slide from side to side on the net cable. This is accomplished by adjusting the net straps as described in step #7. 8.
- Page 12 7200 Collegiate Volleyball System 14. To take volleyball system down; a. Remove antenna. b. Unhook net straps from posts at both ends. c. Crank winch counterclockwise until net cable can be unhooked from snap links. d. Fold net up and transport net and posts to storage. 7210 End Post with Net 7216 Winch Post with Net...
-
Page 13: Maintenance Check Sheet
7200 Collegiate Volleyball System Maintenance 1. General inspection of equipment when used should be performed to ensure no catastrophic failures have occurred during the course of use between yearly inspections. 2. It is recommended that yearly inspections be conducted to determine if any bolts or any other hardware has become worn or loosened. - Page 14 Gared Holdings, LLC Performance Sports Systems Gared Sports 9200 E. 146 Street 9200 E. 146 Street Noblesville, IN 46060 Noblesville, IN 46060 800-848-8034 800-325-2682 www.perfsports.com www.garedsports.com...
Need help?
Do you have a question about the 7200 Series and is the answer not in the manual?
Questions and answers