Table of Contents
Advertisement
ENGLISH
ENGLISH
(Original instructions)
Drilling in wood
Holes in wood can be made with the same twist drill bits used
for metal or with spade bits. These bits should be sharp and
should be pulled out frequently when drilling to clear chips
Drilling in metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The cutting
lubricants that work best are sulfurized cutting oil or lard oil.
Screwdriving
Always use the correct type and size of screwdriver bit.
u
u
amount of washing liquid or soap as a lubricant.
Always hold the tool and screwdriver bit in a straight line
u
with the screw
Troubleshooting
Problem
Possible cause
Unit will not start.
Battery pack not
charged.
Battery pack will not
Charger not plugged
charge.
in.
Surrounding air
temperature too hot or
too cold.
Unit shuts off
Battery pack has
abruptly.
reached its maximum
thermal limit.
Out of charge. (To
maximize the life of
the battery pack it is
designed to shutoff
abruptly when the
charge is depleted
Accessories
The performance of your tool depends on the accessory used.
BLACK+DECKER accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you will get the very best
from your tool.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Your charger does not require any maintenance apart from
regular cleaning.
6
6
Warning! Before performing any maintenance on the tool,
remove the battery from the tool. Unplug the charger before
cleaning it.
Regularly clean the ventilation slots in your tool and
u
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth.
u
Do not use any abrasive or solvent-based cleaner.
Regularly open the chuck and tap it to remove any dust
u
from the interior.
Protecting the environment.
Z
needs replacement, or if it is of no further use to you, do not
dispose of it with household waste. Make this product
available for separate collection.
z
Possible solution
Check battery pack charg-
ing requirements
Plug charger into a work-
ing outlet.
Service Information
Move charger and battery
Black & Decker offers a full network of company-owned and
pack to a surrounding air
authorized service locations throughtout Asia. All Black &
temperature of above 40
Decker Service Centers are staffed with trained personnel to
degrees F (45ºC) or below
105 degrees F (+40.5ºC)
provide customers with efficient and reliable product service.
Whether you need technical advice, repair, or genuine factory
Allow battery pack to cool
down.
replacement parts, contact the Black & Decker location
nearest to you.
Place on charger
and allow to charge.
NOTE
Black & Decker's policy is one of continuous improvement
u
to our products and, as such, we reserve the right to
change product specifications without prior notice.
Standard equipment and accessories may vary by country.
u
Product specifications may differ by country.
u
Complete product range may not be available in all
u
countries.
Contact your local Black & Decker dealers for range
availability.
Batteries
Z
At the end of your products life return the whole unit to your
u
service agent or to a local recycling station to have the
battery recycled. Do not throw the unit out with household
waste.
Separate collection. This product must not be
disposed of with normal household waste.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for
raw materials.
There are no user servicable parts inside.
Te
V
N
M
C
M
S
W
B
V
C
T
Advertisement
Table of Contents
