Operation; Starting Cold Engine - Echo 02006801 Operator's Manual

O
PERATION
NOTE
The blade cover is used for transportation and storage. Remove
blade cover before using the unit.
NOTE
Refer to the Hedge Clipper Safety Manual for additional proper and
safe Trimming Techniques.

STARTING COLD ENGINE

1. Stop Switch
Move stop switch (A) away from the STOP position.
2. Choke
Move choke (B) to the Cold Start (CLOSED) position.
3. Primer
Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible and
flows freely in the clear fuel tank return line. Pump bulb an additional
4 or 5 times.
4. Recoil Starter
Lay the unit on a flat clear area and pull the recoil starter handle (D)
until engine fires.
5. Choke
Move choke (B) to the RUN (OPEN) position. Restart engine if
necessary and allow unit to warm up at idle for several minutes.
WARNING
The blades should not move at idle. If blades move, readjust
carburetor according to "Carburetor Adjustment" instructions in
this manual or see your ECHO Dealer, otherwise serious personal
injury may result.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
DANGER
H C
EDGE LIPPER
O ' M
PERATOR S ANUAL
B
C
B
11
A
D