Electrical Version; Calibrate Temperature - Miele H 7870 BMX Operating And Installation Instructions

Activating/deactivating
The RemoteUpdate function is
activated as standard. Available
updates will be downloaded
automatically but will only be installed if
you initiate installation manually.
Deactivate RemoteUpdate if you do not
want any updates to be downloaded
automatically.
Running a RemoteUpdate
Information about the content and
scope of an update is provided in the
Miele app.
A message will appear on your oven
display if a software update is available.
You can install the update immediately
or postpone this until later. When the
oven is turned on again, you will be
reminded about the update.
Deactivate RemoteUpdate if you do not
want to install the update.
The update may take several minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
an update is available.
- Once an update has been installed, it
cannot be undone.
- Do not turn the oven off during the
update. Otherwise, the update will be
aborted and will not be installed.
- Some software updates can only be
carried out by Miele Customer
Service.

Electrical version

You can set the voltage variant. The
setting must correspond to the voltage
of your domestic electrical supply.

Calibrate temperature

You can change the temperature in
increments in all operating modes and
automatic programs so that it is higher
or lower in the oven compartment than
displayed.
The temperature calibration is
represented by a bar with seven
segments.
       
If all of the segments are filled, the oven
compartment temperature is much
higher than displayed. If one segment is
filled, the oven compartment
temperature is much lower than
displayed.
Settings
49