Electrical Safety - Black & Decker EMAX34 Original Instructions Manual

ENGLISH
Always remove the plug from the socket before
inspecting a damaged cable. Be careful not to
use your appliance if the cable is damaged.
Beware of sharp blades.
K
from the cutting area.
Keep the cable away from the cutting blades..
The blades will continue to rotate after the
machine is switched off.

Electrical safety

#
Warning! This tool is double insulated; therefore
no earth wire is required. Always check that the
power supply corresponds to the voltage on the
rating plate.
If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Electric safety can be further improved by using a high

sensitivity 30 mA Residual Current Device (RCD).
Using an extension cable
Always use an approved extension cable suitable for the

power input of this tool (see technical data). The exte n-
sion cable must be suitable for outdoor use and marked
accordingly. Up to 30 m of 1.5 mm2 HO5VV-F extension
cable can be used without loss of product performance.
Before use, inspect the extension cable for signs of
damage, wear and ageing. Replace the extension cable
if damaged or defective. When using a cable reel, always
unwind the cable completely.
Features
This appliance includes some or all of the following features.
1. Switch box
2. On/off switch
3. Upper handle
4. Intelligent cable management
5. Lower handle
6. Cable storage holders
7. Height adjustment
8. Height of cut gauge
9. EdgeMax
10. Grass collection box
4
(Original instructions)
11.
12. Carry handles
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
The grass box requires assembly before use and comes in 5
pieces.

Clip the 2 sides (15) of the grass collection box together.

Align the assembled sides onto the bottom (16) of the

grass collection box. Ensure that the 4 guides (17) are
Push the 2 parts together. Apply even force around all

edges of the grass collection box securing the clips
into position uniformly. Check that each clip is fastened
together securely.
Align the lid (14) onto the assembled grass collection box.

Note: Take extra care when aligning the 2 clips at the rear of
the grass collection box.
Push down on the lid to secure all clips. Begin at the back

and ensure that all clips are securely located.
Insert the ends of the lower handle (5) into the corre-

sponding holes in the mower.
Press the handle down as far as it will go.

Secure the handle using the screws (19.

Fit the upper handle part (3) to the lower handle (5) using

the knobs (20), washers (21) and screws (22) as shown.
Note:
positions.
Clip the cable to the upper and lower handle using the

restraint clips (23) as shown.

box (10) over the lugs (24).
Warning! Ensure the blade has completely stopped and
disconnect the appliance from the mains.
Warning!