Table of Contents
Advertisement
Do not expose the appliance to
rain or high humidity.
Always remove the plug from
the socket before inspecting
a damaged cable. Be careful
not to use your appliance if the
cable is damaged.
Beware of sharp blades.
Beware of flying objects. Keep
bystanders away from the
cutting area.
Keep the cable away from the
cutting blades.
The blades will continue to
rotate after the machine is
switched off.
Directive 2000/14/EC
guaranteed sound power
96
Electrical safety
Warning! This tool is double
insulated; therefore no earth
wire is required. Always
check that the power supply
corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Electric safety can be further improved
u
by using a high sensitivity 30 mA
Residual Current Device (RCD).
(Original instructions)
Features
This appliance includes some or all of the following features.
1. Power button
2. Comfort grip handles
3. On/off switches
4. Upper handle
5. Handle knobs
6. Lower handle
7. Grass box handle
8. Carrying handle
9. Grass collection box
10. Rear flap
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Assembling the grass collection box (fig. A, B
and C)
The grass box requires assembly before use and comes in 3
pieces.
Clip the handle (7) into the lid (9a) of the grass box
u
(fig. B). The handle will only fit one way round.
Align the lid (9a) onto the base of grass collection box
u
(9b). Ensure that the guides are aligned (fig. C)
Note: Take extra care when aligning the 2 clips at the rear of
the grass collection box.
Push down on the lid to secure all clips. Begin at the back
u
and ensure that all clips are securely located.
Fitting the lower handle (fig. D)
Insert the ends of the lower handles (6) into the
u
corresponding holes in the mower.
Press the handle down as far as it will go.
u
Secure the handle using the screws.
u
Assembling the upper handle (fig. E)
Fit the upper handle (4) to the lower handle (6) using the
u
knobs (5), washers and screws as shown.
Note: The upper handle can be fixed in 2 different height
positions.
Fitting the grass collection box (fig. F)
Lift the flap (10) and place the grass collection box (9)
u
over the lugs.
Proper Hand Position (Fig. G)
Warning! To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
Warning!: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
ENGLISH
11
Advertisement
Table of Contents
