Double Insulation; Electrical Safety - Black & Decker GF834 Manual

• If your mower starts to vibrate
abnormally (check immediately).
• After striking a foreign object, inspect
your mower for damage and make
repairs as necessary.
• Never run your mower whilst lying on its
side or attempt to stop the blade -
always allow it to stop on its own.
• Do not put hands or feet near or under
rotating parts.
• Keep clear of discharge openings at all
times.
• Do not use your mower in the rain and
do not allow it to get wet. Avoid using
your mower in wet grass, if possible.
• Use your mower only in daylight or good
artificial light.
• Do not pull machine towards you or walk
backwards when mowing.
• Do not cross gravel paths or roads whilst
the blade is rotating.
• Always be sure of your footing,
particularly on slopes.
• Always cut across the face of slopes,
never up and down. Exercise extreme
caution when changing direction on
slopes.
• Do not cut excessively steep slopes and
always wear non-slip footwear.
• Check the grassbox for wear or damage
and replace if necessary. Never use your
mower without the grassbox in place.
• Walk, never run. Do not force your mower.
• Never pick up or carry your mower while
the motor is running.
• Ensure the blade has stopped rotating
and take extreme care before lifting your
mower for and during transportation.
• Never operate your mower with defective
guards or shields.
Maintenance and storage
• Store your mower in a dry place when
not in use, out of the reach of children.
• Always disconnect from the electrical
supply before cleaning.
• Do not use solvents or cleaning fluids to
clean your mower - use a blunt scraper
to remove grass and dirt.
• Do not operate your mower if any parts
are defective; discard all defective parts
and fit new parts before use.
• Keep all nuts, bolts and screws tight to
be sure your mower is in a safe working
condition.
ENGLISH
• Use only Black & Decker recommended
replacement parts and accessories.
Black & Decker's policy is one of continuous
improvement to our products and, as such, we
reserve the right to change product specifications
without prior notice.

Double insulation

Your mower is double insulated.
This means that all external metal parts are
electrically isolated from the power supply.
This is achieved by placing an extra
insulation barrier between the electrical and
mechanical parts. Double insulation means
greater electrical safety and obviates the
necessity of having your mower earthed.

Electrical safety

Increased safety can be obtained by having
a qualified electrician install a high sensitivity
(30mA) circuit breaker in the house wiring.
If you do not have such a circuit breaker
installed, or you do not wish to have one
installed, then we strongly recommend that
the electrical power to your mower be
supplied through a high sensitivity residual
current device (RCD). The RCD is designed
to provide a high degree of personal
protection against harmful electric current
should fault conditions occur.
Warning! The use of an RCD or other circuit
breaker unit does not release the operator of
your mower from the safety instructions and
safe working practices given in this manual.
Electrical safety (UK only)
Your mower should always be switched off
at the mains before disconnecting any plug
!
and socket connector or extension cables.
Fuse replacement
If your mower is supplied with cable fitted
with a non-re-wireable plug:
• The plug is fitted with a 13 amp fuse
which is the recommended fuse for
your mower.
• Only use replacement fuses which are
approved to BS1362.
3